Skip to content
noggin

Wiring

Core Port GPIO Servo Range Rest
1 (eyes) 1 3 L lid 39..102 61.4
1 (eyes) 2 2 L eye 58..118 88
1 (eyes) 3 1 R lid 39..102 64
1 (eyes) 4 0 R eye 58..118 88
2 (neck) 1 3 tilt 42.1..139.7 90
2 (neck) 2 2 jaw 53.7..90 90
2 (neck) 3 1 pan 33.9..146.5 90

Ports 1 and 2 are the Shield’s left header, 3 and 4 the right. The eyes Core’s rows are the eye program’s as it runs today, on today’s Mech’s calibration (Calibration): a servo per eye and per lid, the lids in the shared lid frame, the right lid servo’s degrees (the Core writes 180 - a to the left), closed at the low end, open at the high; the eyes rest centred between their ends. The Mech’s eyes Core drives the eye gimbal instead: left and right, up and down, and a lid servo per eye (Stage 1), its ports given when the eye program drives the gimbal. The neck Core has no program yet: its ranges are the neck’s in the model and its rest the model’s neutral, 90 (the jaw’s closed end), and its GPIOs are the Shield’s as on the eyes Core (inferred: the same Shield).

  • Battery -> switch board -> XH2.54 2-pin lead -> shield power input (a Y lead to both shields, split after the neck joint).
  • Shield spec: 7.4 to 12.6 V. A single 3.7 V cell is below spec; two 14500 cells in series (2S) are the minimum. Neither the Core nor the shield charges cells; charge externally.
  • USB-C on the Core powers only the Core, not the servos.
  • What we have: two official 7.4 V 800 mAh 2S packs (two 14500 cells end to end in blue heat-shrink, so each looks like a single cell) and the kit’s USB charger dongle with an XH2.54 plug. The dongle is a charger only, never a supply for the board. One pack in the Torso through the switch board, the spare on charge. USB-C to the Mac carries data and powers the Core only.
  • Servos stay powered at rest: released, the lids and eyes fall under gravity.

The neck Core sits on its own Shield in the head, at +x beside the eyes Core: port 1 tilt, 2 mouth, 3 pan. Both Cores join the Wi-Fi and are addressed directly (ADR 0005; radio facts in docs/research/2026-10-31-radio.md), each antenna 15 mm clear of the Shells, servos, magnets, pack and leads where the build allows. In the next Mech both lie flat in the realistic skull’s cranium, each USB-C socket’s opening straight back through the skull, for flashing and as the fallback (#858; a Core’s USB-C powers that Core alone): check the link there, inside the skull, on the built Mech. Both Shields run off the one pack and switch board through a Y lead (Stage 2); the gestures stay inside the pack’s 3 A, since two Shields at stall would draw more (2 x 2.6 A > 3 A; a pack per Shield was dropped, #51): each Core starts at most two servos at once (the start budget). Electrical figures: docs/research/2026-10-31-electrical.md.

byYellow PineYellow Pine

noggin v0.2.26-6-g09bf9b7 · 09bf9b7